Wall Planners Installation

ESSENTIAL TOOLS

• Hammer

• Level / Plumb

• x4 Screws (x6 For The Large)

• Electric Drill

• x4 Standoffs (x6 For The Large)

• x4 Drywall Plugs (x6 For The Large)

Step 1

MARK THE LOCATION OF YOUR BOARD ON THE WALL

• Carefully position the acrylic board against the wall and use it as a template to mark the holes using a pencil. Use a level to ensure the panel is straight.

Step 2

INSTALLING THE STANDOFFS

• Drill the hole in the centre of each marked circle using a power drill and the proper bit size. Carefully push each drywall plug into the holes using a hammer. Make sure they are flush to the wall.

Step 3

DRILL HOLES ON THE WALL

• Insert the screw into the standoff and carefully screw it onto the drywall plug installed on the wall already. Do the same with all other standoffs. With all standoffs installed, it's time to hang the board.

Step 4

HANGING THE ACRYLIC BOARD

• Carefully remove the protective films from the acrylic board. Align the board with the standoffs and screw each cap. Note: The standoffs come with two spacers that should be installed at both sides of the acrylic, between the standoff and the board on one side and the panel and the cap on the other.

• Enjoy and Happy Planning !

**Best if you do not tighten all of the cap screws until you have all of them in place.